The Spanawave/Giga-tronics 8502A Dual Channel Peak Power combine CW power measurement with the ability to make precise peak power measurements at any point on a pulsed waveform. This dual, built-in capability lets you make CW measurements and analyze pulsed waveforms with a single instrument.

The meter is available in a single or dual channel configuration. A built-in display shows measurements such as rise time, fall time and pulse width plus the pulse profile. And you can use a reference cursor to read peak power at any point on the pulse waveform.

Spanawave/Giga-tronics CW and Peak power sensors contain an EEPROM programmed with the frequency calibration factors measured at the factory, or in your cal lab. When you key in the frequency at which power is being measured, the meter automatically applies the correct cal factor from the sensor EEPROM.

>> Click here for Sensor to Meter Compatibility Chart Overview

Rise time < 15 ns
Sensor frequency range from 0.03 or 0.75 to 18.5, 26.5 or 40 GHz
Power Range: -20 to ±20 dBm Pulse; -40 to +20 dBm CW
Measurement resolution is 100 ps
Measure the same point on repetitive pulses at over 70 measurements/second
Built-in power sweep calibrator with NIST traceable accuracy

	Model #
	16934A Standard Peak Power Sensor 750 nS, 30 MHz to 18 GHz, N(m)
	16935A Standard Peak Power Sensor 750 nS, 30 MHz to 18 GHz, APC-7
	16936A Fast Rise Time Peak Power Sensor 15 nS, 750 MHz to 18 GHz, N(m)
	16937A Fast Rise Time Peak Power Sensor 15 nS, 750 MHz to 18 GHz, APC-7
	17071A Fast Rise Time Peak Power Sensor 15 nS, 750 MHz to 40 GHz, K(m)
	17266A Fast Rise Time Peak Power Sensor 15 nS, 750 MHz to 26.5 GHz, K(m)
	17267A Standard Peak Power Sensor 750 nS, 30 MHz to 26.5 GHz, K(m)
	32353 8500 Series Calibration Kit
	Option 01 Rack Mount Kit
	Option 03 8501A Rear Panel Sensor and Calibrator Connectors (deletes all front panel connectors)
	Option 10 Firmware Version 2.10A

Documentation:

Model 8502A Dual Channel Peak Power Meter